ESP8266 breadboard adapter board

PCB_small

Markus designed a single-sided ESP-12/ ESP-07 breadboard adapter PCB:

Features are:
– Fits ESP-12 and ESP-07 module
– Single-sided self-etchable design
– Few, cheap parts in SMD
– Breadboard-style – one row on each side accessible
– Vin >4.5V (max. 7V) input possible with 3V3 onboard voltage regulator (with two capacitors 10µF)
– Power-indicator LED
– (Schottky-) Diode as reverse polarity input protection possible (solder 0 Ohm resistor or just connect the two pads for no protection)
-RST, CH_PD, GPIO0 with 4k7 pull-up resistors on board (resistors can be omitted if remote access of those GPIOs is needed)
– GPIO15 with 4k7 pull-down (see above)
– Tactile switch connected to GPIO0 to get into flash mode
– Single post for 3.3V output near voltage regulator

Project info at Wireless Sensor Networks blog.

Leave a Reply

Your email address will not be published. Required fields are marked *